| 产地 | 深圳 |
|---|---|
| 设备类型 | 其它 |
| 品牌 | HI-link |
| 型号 | HLK-RM10 |
| 加工定制 | 是 |
您在购买RM10模块时建议您同时购买天线，以方便您更精准的测试，RM10是需要外带天线的，您可以联系客服购买
HLK-RM10是一种新的低成本嵌入式UART-ETH-WIFI模块(串口-网络以太网方式)由深圳Hi-link电子有限公司有限公司
本产品是嵌入式模块基于通用串行接口的网络标准,内置TCP / IP协议栈,使用户串行端口,以太网、无线网络(wifi)onversions之间的接口。通过HLK-RM10模块,传统的串行设备不需要改变任何配置,数据可以通过互联网传播网络。为用户提供一个快速解决方案的串行设备通过以太网传输数据
Pin Assignment
Pin No | Signal Type | Description |
1 | 3.3VD | Supply Voltage, 3.3V+/-10% |
2 | GND | Analogue Ground |
3 | RXD | UART1 RXD |
4 | RTS | UART1 RTS |
5 | TXD | UART1 TXD |
6 | WPS/RST | WiFi Protected Setup /Restore factory value |
7 | CTS | UART1 CTS |
8 | UART_TX | UART0 TXD |
9 | UART_RX | UART0 RXD |
10 | link1 | 10/100 PHY Port #1 activity LED |
11 | RXIP1 | 10/100 PHY Port #1 RXP |
12 | RXIN1 | 10/100 PHY Port #1 RXN |
13 | TXOP1 | 10/100 PHY Port #1 TXP |
14 | TXON1 | 10/100 PHY Port #1 TXN |
15 | TXON2 | 10/100 PHY Port #2 TXN |
16 | TXOP2 | 10/100 PHY Port #21 TXP |
17 | RXIP2 | 10/100 PHY Port #2 RXP |
18 | RXIN2 | 10/100 PHY Port #2 RXN |
19 | I2C_CLK | General GPIO Reserved |
20 | I2C_SD | General GPIO Reserved |
21 | ES/RST | Exit transparent transmission mode/Restore factory value |
22 | USB_M | Reserved |
23 | USB_P | Reserved |
24 | link2 | 10/100 PHY Port #2 activity LED |
25 | WLAN_LED | WLAN Activity LED |
26 | VO1.8 | 1.8V Output (Suuport Atmost 300mA) |
27 | GND | Analogue Ground |
28 | 3.3VD | Supply Voltage, 3.3V+/-10% |
